To Next Page

To Previous Page

4 Type the command fs0:/fs1: to enter the le system and locate the le.

NOTE: File system partitions may vary depending on your system conguration. Browse through the fsx to locate the USB

disk.

5 Run the le run.nsh to ash the rmware.

6 On successful update of rmware type Exit to exit from the UEFI shell and reboot the system.

7 Verify the installed rmware version in HII, iDRAC or BOSS-S1 CLI.

Firmware update using BOSS-S1 CLI

Download the appropriate CLI application le from Dell.com/support for your Windows or Linux operating system.

Firmware update using Windows

Following are the steps to update the rmware using the BOSS-S1 command line interface.

1 Download the SAS-RAID_Firmware_xxxxx_UEFI_Axx.zip from Dell.com/support and extract the zip le.

2 Open the vs2015/windows folder. Example: C:\Desktop\mvsetup.xxxxx_Axx\windows\x64\cli

3 Copy the rmware image binary from the SAS-RAID_Firmware_xxxxx_UEFI_Axx.zip folder to the directory where CLI le is located.

Overwrite any existing les.

NOTE: BOSS-S1 supports multiple sub device ID. Locate the correct sub device ID which is available in the iDRAC, BOSS-S1

HII, and BOSS-S1 OS CLI (Info -o hba).

Table 3. Supported SubDevice ID

SubDevice ID Firmware Binary Link

1FD6 (Monolithic) ImageA1_1FD6.bin

1FE2 (Monolithic) ImageA1_1FE2.bin

1FDF (Modular) ImageA1.bin

4 Run mvsetup.exe.

5 To ash the rmware, run the command flash –a update –f ImageA1_xxxx.bin –t raw in the CLI shell.

6 Exit and reboot the system, and verify the rmware version.

NOTE

: Administrator privileges for Windows and Root/Sudo for Linux are recommended.

Firmware update using Linux

Perform the following steps to update your rmware using the Linux BOSS-S1 command line interface (CLI):

1 Download the SAS-RAID_Firmware_xxxxx_UEFI_Axx.zip from Dell.com/support.

2 Locate the folder which contains the downloaded the CLI le, for example: C:\Home\Desktop\mvcli.xxxx_Axx\x64\cli.

3 Copy the rmware image binary from the SAS-RAID_Firmware_xxxxx_UEFI_Axx.zip folder to the directory where the CLI le is

located. Overwrite any existing les.

NOTE

: The BOSS-S1 card supports multiple subdevice IDs. Locate the correct subdevice ID, available in the iDRAC, BOSS-

S1 HII, and BOSS-S1 operating system CLI (Info -o hba).

10 Overview

Brand	Dell EMC
Model	Boot Optimized Server Storage-S1
Category	Server
Language	English

Dell EMC Boot Optimized Server Storage-S1 User Manual

Questions and Answers: