working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
NOTE: Applicable only for computers that are shipped with fingerprint reader.
Procedure
1. Using the alignment posts, align and place the power button on the palm rest and keyboard assembly.
2. Place the power-button with fingerprint-reader board onto the slot on the palm rest and keyboard assembly.
3. Adhere the fingerprint reader cable on the palm rest and keyboard assembly.
Post-requisites
1. Replace the system board.
2. Replace the display assembly.
3. Replace the hard drive.
4. Replace the solid-state drive/Intel Optane.
5. Replace the heat sink.
NOTE:
The system board can be removed and installed together with the heat sink still attached.
6. Replace the fan.
7. Replace the wireless card.
8. Replace the memory modules.
9. Replace the battery.
10. Replace the base cover.
Removing and installing components
55
To Next Page
Loading...
