2. Note the routing of the display cable and antenna cable, and then remove the cables from the display hinges.
3. Remove the ten screws (M2x2) that secure the display hinges to the display back-cover and antenna assembly.
4. Lift the display hinges off the display back-cover and antenna assembly.
Replacing the display hinges
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Align the screw holes on the display hinges with the screw holes on the display back-cover and antenna assembly.
2. Replace the ten screws (M2x2) that secure the hinges to the display back-cover and antenna assembly .
Removing and installing components
69
To Next Page
Loading...
