working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1. Place the display panel on a flat and clean surface.
2. Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable.
3. Adhere the tape that secures the display cable to the back of the display panel.
4. Turn the display panel over and align the screw holes on the display panel with the screw holes on the display back-cover and antenna
assembly.
5. Replace the four screws (M2x2) that secure the display panel to the display back-cover and antenna assembly.
Removing and installing components
67
To Next Page
Loading...
