Steps
1. Align and place the system board on the palmrest.
2. Peel back the Mylar tape from over the screw hole.
3. Replace the two (M2x4) screws that secures the system board to the palmrest.
4. Connect the following cables to the system board:
a. Speaker cable
b. Keyboard FFC
c. Keyboard backlight FFC
d. Touchpad FFC
e. Hard drive FFC
f. IO board FFC
g. Power adapter port cable
h. Fingerprint reader FFC
i. Power button FFC from the system board
Next steps
1. Install the display assembly.
2. Install the heatsink.
3. Install the system fan.
4. Install the memory
5. Install the SSD.
6. Install the WLAN.
7. Install the battery.
8. Install the base cover.
9. Install the SD card.
10. Follow the procedure in after working inside your computer.
76
Disassembly and reassembly
To Next Page
Loading...
