Dell 2007FP - Universal Serial Bus (Usb) Specific Problems

5/7
support.dell.com/support/edocs/monitors/2007FP/en/ug/solve.htm#Monitor Specific Troubleshooting
Cannot adjust the monitor with
the buttons on the front panel
OSD does not appear on the screen Turn the monitor off and unplug the pow er
cord and then plug back and power on
The monitor will not go into
power saving mode.
No picture, the LED light is green. When press "+",
"-" or "Menu" key, the message " No S-Video input
signal " or " No Composite input signal " will
appear.
Move mouse or hit any key on the
keyboard on the computer or activate
video player, then access the OSD to set
Audio to " off " state.
No Input Signal when user
controls pressed
No picture, the LED light is green. When press "+",
"-" or "Menu" key, the message " No S-Video input
signal " or " No Composite input signal " will
appear.
Check the signal source Make sure the
Computer is not in power saving by moving
mouse or pressing any key on the
keyboard.
Check to make sure Video Source to S-
Video, Composite or Component is
powered and playing video media.
Check whether the signal cable is plugged
in and seated properly. Re-plug the signal
cable if necessary.
Re-boot the computer or video player.
The monitor will not fill the entire
screen.
The picture can't fill the height or width of the
screen.
Due to the non-standard formats of DVDs,
the monitor may not show the full screen
pictures.
NOTE: When choosing DVI-D mode, Auto Adjust function is not available.
Universal Serial Bus (USB) Specific Problems
SPECIFIC SY MPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
USB interface is not working USB peripherals are not working Check that your monitor is pow ered ON.
Reconnect the upstream cable to your computer.
Reconnect the USB peripherals (downstream connector).
Switch off and then turn on the monitor again.
Reboot the computer.
High Speed USB 2.0 interface
is slow.
High Speed USB 2.0 peripherals working
slowly or not at all.
Check that your computer is USB 2.0 capable.
Verify USB 2.0 source on your computer.
Reconnect the upstream cable to your computer.
Reconnect the USB peripherals (downstream connector).
Reboot the computer.