Dell 8 - Page 113

About Your System 113
DIMMs <A1-A8>
disabled - MemBIST
error.
The memory modules are
not properly seated.
The memory module
connector may be exposed
to dust.
Unsupported memory
module.
Replace or reseat the
memory module(s). See
"System Memory" on
page 159.
Ensure that the memory
module connectors are clean
and supported memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines -
PowerEdge M910" on
page 161.
DIMMs <A1-A8>
disabled - MemBIST
timeout.
DIMMs <A1-A8>
disabled - Rank
not found.
DIMMs <A1-A8>
disabled - DIMM
communication
error.
DIMMs <A1-A8>
disabled - DDR
training error.
DIMMs <A1-A8>
disabled - Simple
memory test
failure.
DIMMs <A1-A8>
disabled - No
memory detected.
The memory modules are
not properly seated.
The memory module
connectors may be
exposed to dust.
Unsupported memory
module.
Replace or reseat the
memory module(s). See
"System Memory" on
page 159.
Verify that the memory
modules are identical and in
a lock-step pair.
DIMMs <A1-A8>
disabled - Invalid
DIMM.
Unsupported memory
modules in the first locked
step pair.
See "General Memory
Module Installation
Guidelines - PowerEdge
M910" on page 161.
Replace the memory
modules. See "System
Memory" on page 159.
Table 1-26. Blade Messages
(continued)
Message Causes Corrective Actions