53
Operating the monitor
Figure 43. Warning message of changing the default setting
NOTE: If you select Yes for either of the features mentioned above, the message will not appear the next time you change the
settings of these features. When you perform a factory reset, the message will appear again.
You will see the following message when the monitor enters the Standby Mode:
Going into Standby mode...
Figure 44. Warning message of entering Standby Mode
NOTE: The message may vary slightly depending on the connected input signal.
Activate the computer and wake up the monitor to gain Accessing the Menu Launcher.
The OSD functions only in the normal operation mode. You will see the following message if you press the joystick button during the
Standby Mode depending on the selected input:
Figure 45. Warning message for accessing the Menu Launcher
NOTE: The message may vary slightly depending on the connected input signal.
Activate the computer and wake up the monitor to gain Accessing the Menu Launcher.
You will see the following message if DP, HDMI 1, or HDMI 2 input is selected and the corresponding cable is not connected:
Figure 46. Warning message for no DP cable
or
Figure 47. Warning message for no HDMI 1 cable
or
To Next Page
Loading...
