27
About your monitor
Maintenance guidelines
Cleaning your monitor
CAUTION: Read and follow the Safety instructions before cleaning the monitor.
WARNING: Before cleaning the monitor, unplug the monitor power cable from the electrical outlet.
For best practices, follow the instructions that are listed below when unpacking, cleaning, or handling your monitor:
• Use a clean cloth that is slightly dampened with water to clean the stand assembly, the screen, and the chassis of your Dell
monitor. If available, use a screen-cleaning tissue or solution suitable for cleaning Dell monitors.
• After cleaning the surface of the table, ensure that it is thoroughly dry and free from any moisture or cleaning agent before
placing your Dell monitor on it.
CAUTION: Do not use detergents or other chemicals such as benzene, thinner, ammonia, abrasive cleaners, or
compressed air.
CAUTION: Using chemicals for cleaning may cause changes in the appearance of the monitor, such as color fading, milky
film on the monitor, deformation, uneven dark shade and peeling of screen area.
WARNING: Do not spray the cleaning solution or even water directly on the surface of the monitor. Doing so allows
liquids to accumulate at the bottom of the display panel and corrode the electronics resulting in permanent damage.
Instead, apply the cleaning solution or water to a soft cloth and then clean the monitor.
NOTE: Monitor damages due to improper cleaning methods and the use of benzene, thinner, ammonia, abrasive cleaners,
alcohol, compressed air, detergent of any kind leads to a Customer Induced Damage (CID). CID is not covered under the
standard Dell warranty.
• If you notice white powder when you unpack your monitor, wipe it off with a cloth.
• Handle your monitor with care as a darker colored monitor may get scratched and show white scuff marks more than a lighter
colored monitor.
• To help maintain the best image quality on your monitor, use a dynamically changing screen saver and turn off your monitor when
not in use.
To Next Page
Loading...
