0101
0101
/
CHAPTER 20: BLUETOOTH ASSEMBLY
Replacing the Bluetooth Assembly
Follow the instructions in “Before You Begin” on page 1. 6.
Align the tabs on the Bluetooth assembly with the slots on the chassis.2.
Tighten the thumbscrew that secures the Bluetooth assembly to the 3.
chassis.
Connect the Bluetooth assembly cable to the connector on the master I/O 4.
board.
Replace the drive-bay shroud (see “Replacing the Drive-Bay Shroud” on 5.
page 19).
Close the PCI shroud (see “Closing the PCI Shroud“ on page 6. 18).
Replace the left side-panel (see “Replacing the Left Side-Panel” on page 7. 11).
Connect your computer and devices to electrical outlets and then turn 8.
them on.
To Next Page
Loading...
