110 Brocade Adapters Installation and Reference Manual
53-1002144-01
Updating drivers with HCM
3
Windows systems
For Windows systems, use the following steps.
1. Go to the following directory where the SNMP files are installed.
c:\program files\brocade\adapter
2. Enter one of the following commands:
• brocade_install.bat SNMP=TRUE
Installs the SNMP subagent, drivers, and other utilities.
• brocade_install.bat SNMP_ONLY=TRUE
Installs only the SNMP subagent.
3. Start SNMP services using the following commands.
• service <snmpd> start
This starts the master agent “snmpd” service if it is not already running.
• service <bnasd> start
This starts the subagent “bnasd” service.
4. Start SNMP subagent services using the following steps.
a. Open Services (typically Start>Control Panel>Administrative Tools>Services)
b. Right-click SNMP and select Start.
Linux systems
1. Go to the following directory where the subagent files are installed.
/opt/brocade/adapter
2. For RHEL systems, enter one of the following commands:
• Enter brocade_install_rhel.sh --snmp to install the SNMP subagent, drivers, and other
utilities.
• Enter brocade_install_rhel.sh --snmp-only to install the SNMP subagent only
3. For SLES systems, enter one of the following commands:
• Enter brocade_install_rhel.sh --snmp to install the SNMP subagent, drivers, and other
utilities.
• Enter brocade_install_rhel.sh --snmp-only to install the SNMP subagent only
Updating drivers with HCM
You can update installed drivers on connected hosts using the Adapter Software dialog box in HCM.
Updating the driver updates all of the following components to the latest versions:
• Network and storage driver
• HCM Agent
• initrd file (Linux systems)
To Next Page
Loading...
