116 Brocade Adapters Installation and Reference Manual
53-1002144-01
Setting IP address and subnet mask on CNAs
3
Linux
Following is an example for using the ifconfig command to set the IP address and subnet mask.
Note that a CNA and a Fabric Adapter with ports configured in CNA or NIC mode are typically named
“eth0.”
ifconfig eth0 193.164.1.10 netmask 255.255.255.0 up
VMware
Please refer to ESX/ESXi Configuration Guide on network configuration for VMware ESX/ESXi 4.x
and 5.0.
To Next Page
Loading...
