Brocade Adapters Installation and Reference Manual 13
53-1002144-01
Host bus adapters
1
Using Brocade HBAs, you can connect your host system to devices on the Fibre Channel SAN. The
combined high performance and proven reliability of a single-ASIC design makes these HBAs ideal
for connecting hosts to SAN fabrics based on Brocade Fabric or M-Enterprise operating systems.
This publication only supports the HBA models listed in Table 5, and does not provide information
about the Brocade 410 and 420 Fibre Channel HBAs, also known as the Brocade 400 Fibre Channel
HBAs.
Stand-up models
Figure 6 on page 13 illustrates major components of the Brocade 825 stand-up model HBA. Please
note that the following illustration is representative and may have minor physical differences from
the HBA that you purchased.
FIGURE 6 825 HBA with low-profile mounting bracket (head sink removed)
1 LEDs for port 1 SFP
2 Fiber optic cable connectors for port 1 and port 0 SFPs
3 LEDs for port 0 SFP
4 Low-profile mounting bracket. Note: The HBA ships with the low-profile mounting bracket installed.
5 PCIe x8 PCIe connector
6ASIC
7 Serial number label
8 Label showing PWWN for each port.
To Next Page
Loading...
