Brocade Adapters Installation and Reference Manual 141
53-1002144-01
Boot over SAN
4
10. Select the LUN on the target device you that want to designate as the boot LUN for the host.
This must be the same LUN that you bound to the adapter port using the storage system’s
management or configuration utility (refer to step 8 under “Procedures” on page 134).
You only need to select the bootable LUN once. After the first boot, the same LUN will be used
until changed through the BIOS Configuration Utility.
11. Press Enter. The selected device will be added to the list of boot devices for the adapter.
12. Save or exit the configuration utility.
• To save the configuration, press the Alt and S keys.
• To exit without saving press the Alt and Q keys.
To Next Page
Loading...
