Brocade Adapters Installation and Reference Manual 215
53-1002144-01
Network driver parameters
A
FIGURE 22 Advanced Properties dialog box for team
An instance of a physical port that is part of a team displays in the Device Manager as
“Team#Team Name” followed by the physical adapter name, for example, “Team#Failover Brocade
10G Ethernet Adapter.” Right-clicking this instance displays a Properties dialog box labeled
“Team#Failover Brocade 10G Ethernet Adapter.” The Advanced tab contains the same parameters
as shown in Figure 21 on page 214 for the physical port. Note that you cannot configure the
parameters in this dialog box that are configured for a team without removing the port as a
member of the team. However, you can configure other parameters, such as VLAN ID, Receive
Buffers, Autorecovery, or Priority and VLAN Support, as they are not team parameters.
To Next Page
Loading...
