Initial Settings Procedures Using Control Panel
29
10
Select [No Passcode Required].
11
Select [Save].
12
Select [Smart Card Certificate Verification].
13
Select [Change Settings].
14
Select [Enabled].
15
Select [Save].
Note • After the Smart Card feature is enabled and the machine reboots, the machine may receive
a “121-318” fault code. This is normal, and the machine will reboot again after several
seconds.
• Generally, the object identifier settings for Smart Card certificate are not required. For
more information, refer to "Smart Card Certificate - Object Identifiers" (P.44).
Set Access Control
1
Select [Authentication/Security Settings] on
the [Tools] screen.
2
Select [Authentication].
To Next Page
Loading...
