Installing the touchpad
1 Place the touchpad into the slots on the computer.
2 Tighten the M2xL3 screws that secure the touchpad to the system.
3 Ax the adhesive tape that secures the touchpad cable to the touchpad.
4 Place the metal bracket and tighten the M2xL3 screws that secure the metal bracket to the touchpad..
5 Connect the touchpad cable to its connector on the system board.
6 Install the:
a battery
b base cover
c microSD card
7 Follow the procedure in After working inside your computer.
System board
Removing the system board
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a microSD card
b base cover
c battery
d display assembly
3 Disconnect the following cables from their connectors:
a WLAN antenna cables from the WLAN card [1].
b Touchpad cable from its connector on the system board [2].
c Keyboard cable from its connector on the system board [3].
Removing and installing components
19
To Next Page
Loading...
