Removing and installing components
This section provides detailed information on how to remove or install the components from your computer.
Recommended tools
The procedures in this document require the following tools:
• Phillips #0 screwdriver
• Phillips #1 screwdriver
• Plastic scribe
microSD card
Removing microSD card
1 Follow the procedure in Before working inside your computer.
2 Press in on the microSD card to release it from the computer.
3 Remove the microSD card from the computer.
Installing microSD card
1 Slide the microSD card into its slot until it clicks into place.
2 Follow the procedure in After working inside your computer.
Base cover
Removing the base cover
1 Follow the procedure in Before working inside your computer.
2 To remove the base cover:
a Using a screwdriver, rst remove the Mylar caps and then remove the two middle screws.
b Loosen the M2.5xL8.5 captive screws that secure the base cover to the computer [2].
2
8 Removing and installing components
To Next Page
Loading...
