Table 21. System Configuration (continued)
Option Description
● Enabled (default)
● Enabled w/PXE
UEFI Network Stack Allows pre-OS and early OS networking features to use any enabled NICs. This may be used
without PXE turned on.
● Enable UEFI Network Stack
● Default - (Disabled)
Serial Port Determines how the built-in serial port operates.
Choose any one option:
● Disabled
● COM1 (selected by default)
● COM2
● COM3
● COM4
SATA Operation Allows you to configure the operating mode of the integrated hard drive controller.
● Disabled = The SATA controllers are hidden
● AHCI = SATA is configured for AHCI mode
● RAID ON = SATA is configured to support RAID mode (selected by default)
Drives Allows you to enable or disable the various drives onboard:
● SATA-0 (enabled by default)
● SATA-1 (enabled by default)
● SATA-2 (enabled by default)
● SATA-3 (enabled by default)
● M.2 PCIe SSD-0 (enabled by default)
● M.2 PCIe SSD-1 (enabled by default)
Smart Reporting This field controls whether hard drive errors for integrated drives are reported during system
startup. The Enable Smart Reporting option is disabled by default.
USB Configuration Allows you to enable or disable the integrated USB controller for:
● Enable USB Boot Support
● Enable Front USB Ports
● Enable Rear USB Ports
● Enable Internal USB Port
All the options are enabled by default.
Front USB Configuration Allows you to enable or disable the front USB ports. All the ports are enabled by default.
● Front Port 1 (Left)
● Front Port 2 (Center)
● Front Port 3 (Right)*
All the options are enabled by default.
Rear USB Configuration Allows you to enable or disable the back USB ports. All the ports are enabled by default.
● Rear Port 1 (Left)*
● Rear Port 2 (Right)*
All the options are enabled by default.
Internal USB Configuration Allows you to enable or disable the Internal USB port. The port is enabled by default.
● Internal Port 1
Thunderbolt Adapter
Configuration
When enabled the Thunderbolt technology feature and associated ports and adapters are
enabled. This option is enabled by default.
● Enable Thunderbolt Technology Support (Default)
● Security Level - No Security
42 System setup
To Next Page
Loading...
