Identifier GUID-B0E40B48-2D19-4F52-8025-E9A33DAC227A
Version 2
Status Released
Thermal configuration
Table 28. Thermal configuration
Option Description
Thermal Mode Allows you to determine the speed of the system fans. This option is enabled by default.
● Low
● Auto (Default)
This option is set to Auto by default.
NOTE: This setting applies to all the Zone
CPU Zone Allows you to control the minimum and maximum fan speed in the CPU Zone. The range of
characters is between 0 and 100.
NOTE: When Thermal Mode is set in auto, Zero is the optimal speed level.
PSU Zone Allows you to control the minimum and maximum fan speed in the PSU Zone. The range of
characters is between 0 and 100.
NOTE: When Thermal Mode is set in auto, Zero is the optimal speed level.
PCIe Zone Allows you to control the minimum and maximum fan speed in the PCIe Zone. The range of
characters is between 0 and 100.
NOTE: When Thermal Mode is set in auto, Zero is the optimal speed level.
Identifier GUID-567FE5D2-00FE-476D-AF72-55A8E9636297
Version 2
Status Released
Post behavior
Table 29. POST Behavior
Option Description
Numlock LED Allows you to enable or disable the Numlock feature when your computer starts. This option
is enabled by default.
Keyboard Errors Allows you to enable or disable the keyboard error reporting when the computer starts. The
option EnableKeyboard Error Detection is enabled by default.
Extend BIOS POST Time This option creates an additional preboot delay.
● 0 seconds (default)
● 5 seconds
● 10 seconds
Full Screen Logo This option will display full screen logo if your image match screen resolution. The option
Enable Full Screen Logo is not set by default.
Warnings and Errors This option causes the boot process to only pause when warning or errors are detected.
Choose any one of the options:
● Prompt on Warnings and Errors—Default
● Continue on Warnings
● Continue on Warnings and Errors
48 System setup
To Next Page
Loading...
