132 Appendix
Boot Sequence
This feature allows you to set the order in which the BIOS will search devices when trying to find an 
operating system.
  NOTICE: If you modify any boot sequence settings, save the new settings to avoid losing the changes.
Option Settings
  NOTE: The computer attempts to boot from all bootable devices, but if no bootable device is found, the computer 
generates an error message that states No boot device available. Press the <F1> key to retry the boot, 
or press the <F2> key to enter the setup utility.
•
Onboard or USB Floppy Drive —
 The computer attempts to boot from the floppy drive. If there is no 
floppy in the drive or there is no floppy drive installed, the computer attempts to boot from the next 
bootable device in the sequence.
  NOTE: If there is a non-bootable floppy in the drive, the computer generates an error message. Follow the 
on-screen instructions to retry the boot. 
•
Onboard SATA Hard Drive
 — The computer attempts to boot from the primary hard drive. If no 
operating system is on the drive, the computer attempts to boot from the next bootable device.
Maintenance
Service Tag Displays the system service tag which is a unique seven-digit alphanumeric 
system identifier. 
SERR Message Controls SERR message mechanism to support some add-in cards. 
Load Defaults Allows you to reset all options in the setup menu to the factory default. 
Event Log Displays the system event log.
POST Behavior
Fastboot When set to On (default), your computer starts more quickly because it skips 
certain configurations and tests.
Numlock Key This option involves the rightmost bank of keys on your keyboard. When set 
to On (default), this option activates the numeric and mathematical features 
shown at the top of each key. When set to Off, this option activates the 
cursor-control functions labeled on the bottom of each key.
POST Hotkeys This option allows you to specify the function keys to display on the screen 
when the computer starts.
Keyboard Errors This option disables or enables keyboard error reporting when the computer 
starts.