Dell Dimension DMC - Booting to a USB Device; Turning off Your Computer

18 Setting Up and Using Your Computer
www.dell.com | support.dell.com
Booting to a USB Device
NOTE: To boot to a USB device, the device must be bootable. To make sure your device is bootable,
check the device documentation.
To restart your computer to a USB device such as a floppy drive, memory key, or CD-RW drive:
1 Connect the USB device to a USB connector..
2 Shut down (see page 18) and restart the computer.
3 Turn on the computer. When the DELL™ logo appears, press <F12> immediately.
If you wait too long and the Microsoft
®
Windows
®
logo appears, continue to wait until you
see the Windows desktop. Then shut down your computer through the
Start menu and try
again.
NOTE: This procedure changes the boot sequence for one time only. On the next start-up, the computer
boots according to the devices specified in system setup.
4
When the boot device list appears, highlight USB Flash Device and press <Enter>.
The computer restarts to the connected USB device.
Turning Off Your Computer
NOTICE: To avoid losing data, turn off your computer by performing a Microsoft
®
Windows
®
operating
system shutdown, as described next, rather than by pressing the power button.
1
Save and close any open files, exit any open programs, click the Start button, and then click
Turn Off Computer .
2 In the Turn off computer window, click Turn off .
The computer turns off after the shutdown process finishes.