76 Adding Parts
www.dell.com | support.dell.com
  NOTICE: If you remove your original memory modules from the computer during a memory upgrade, 
keep them separate from any new modules that you may have, even if you purchased the new modules 
from Dell. You should install your original memory modules in pairs either in connectors DIMM1 and 
DIMM2 or connectors DIMM3 and DIMM4. If possible, do not pair an original memory module with a new 
memory module. Otherwise, your computer may not function at optimal performance.
 
NOTE: Memory purchased from Dell is covered under your computer warranty.
Installing Memory
  CAUTION: Before you begin any of the procedures in this section, follow the safety instructions 
located in the Product Information Guide.
1
Shut down the computer through the 
Start
 menu (see page 18).
2
Ensure that your computer and attached devices are turned off. If your computer and 
attached devices did not automatically turn off when you shut down your computer, turn 
them off now.
  NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it 
from the network wall jack.
3
Disconnect any telephone or telecommunication lines from the computer.
4
Disconnect your computer and all attached devices from their electrical outlets, and then 
press the power button to ground the system board.
  CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet 
before opening the cover.
5
Remove the computer cover (see page 55).
6
Lay the computer on its side so that the system board is on the bottom of the inside of the 
computer.
  NOTE: For easier access to the memory modules, remove the AGP card (see page 62) first.
7
If necessary, remove a memory module:
a
Press out the securing clip at each end of the memory module connector.
b
Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it 
from the connector.
8
To insert a module, press out the securing clip at each end of the memory module connector.