Adding Parts 63
4
If your computer did not previously have an AGP card installed, move the monitor cable to
the VGA connector on the new card.
5
Replace the computer cover (see page 78).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
6
Connect your computer and devices to electrical outlets, and turn them on.
Adding or Replacing a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a soft
surface, such as a foam pad, that will sufficiently cushion it.
1
Shut down the computer through the
Start
menu (see page 18).
2
Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer, turn
them off now.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it
from the network wall jack.
3
Disconnect any telephone or telecommunication lines from the computer.
4
Disconnect your computer and all attached devices from their electrical outlets, and then
press the power button to ground the system board.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
filler bracket
securing screw
To Next Page
Loading...
