70 Adding Parts
www.dell.com | support.dell.com
15
Connect your computer and devices to electrical outlets, and turn them on.
16
After you turn on your computer, press <F2> when you are prompted to enter setup mode.
17
Highlight
Drive Configuration
and press <Enter>.
18
Use the left and right arrows to change
Diskette Drive A
from
Not Installed
to
3.5 inch,
1.44MB
.
19
Press <Enter>.
20
Highlight
Integrated Devices (LegacySelect Options)
and press <Enter>.
21
Make sure that the
Diskette Interface
entry is set to
Auto
. If necessary, use the left and right
arrows to set it to
Auto
.
22
Press <Enter>.
23
Press <Esc>.
24
Press <Enter> to save changes and exit.
The computer restarts.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
Adding a Second CD or DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
1
Shut down the computer through the
Start
menu (see page 18).
NOTE: Drives sold by Dell come with their own operating software and documentation. After you install a
drive, see the documentation that came with the drive for instructions on installing and using the drive
software.
2
Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer, turn
them off now.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it
from the network wall jack.
3
Disconnect any telephone or telecommunication lines from the computer.
4
Disconnect your computer and all attached devices from their electrical outlets, and then
press the power button to ground the system board.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
5
Remove the computer cover (see page 55).
To Next Page
Loading...
