64 Adding Parts
www.dell.com | support.dell.com
5
Remove the computer cover.
NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted
metal surface, such as the metal at the back of the computer. While you work, periodically touch an
unpainted metal surface to dissipate any static electricity that could harm internal components.
6
Remove the existing hard drive.
7
Remove the additional hard drive bracket from the computer:
a
Remove the bracket-securing screws for the additional drive.
b
Remove the bracket for the additional drive from the computer.
8
If you are replacing the additional hard drive, remove the drive from the bracket:
a
Remove the hard drive-securing screws.
b
Remove the hard drive from the bracket.
NOTICE: Ground yourself by touching an unpainted metal surface on the back of the computer.
NOTICE: When you unpack the drive, do not set it on a hard surface, which may damage the drive.
Instead, set the drive on a soft surface, such as a foam pad, that will sufficiently cushion it.
bracket-securing
screw
drive bracket
hard drive-securing
screws (3)
existing hard drive
bracket-securing
screw
empty drive bracket for
second hard drive
To Next Page
Loading...
