Adding Parts 77
9
Align the notch on the bottom of the module with the crossbar in the connector.
NOTICE: To avoid breaking the memory module, do not press near the middle of the module.
10
Insert the module straight down into the connector, ensuring that it fits into the vertical
guides at each end of the connector. Press firmly on the ends of the module until it snaps into
place.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the
module.
securing clips (2)
connector
memory connector closest
to microprocessor
notch
memory module
cutouts (2)
crossbar
To Next Page
Loading...
