72 Adding Parts
www.dell.com | support.dell.com
7
Pull the two front-panel tabs towards you, and then push out the front-panel insert.
8
Ensure that the jumper setting on the new drive is set for "cable select" (see the
documentation that came with the drive for information).
9
Remove two extra alignment screws, shown in the illustration on page 72, from the front of
the computer and insert them into the drive.
NOTE: Some computers come with only two extra alignment screws; others come with four. You only
need two alignment screws for this procedure.
10
Gently slide the drive into place.
tabs (2)
insert
drive
alignment screws (2)
To Next Page
Loading...
