Dell Dimension E520 - Page 63

Removing and Installing Parts: Dell Dimension E520 Service Manual
file:///T|/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]
Reader.
1 Media Card Reader 2 screws (4)
7. Gently slide the Media Card Reader into place until you feel a click or feel the drive securely installed.
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
8. Connect the USB cable to the back of the Media Card Reader and to the USB connector on the system board (see
System Board Components
).
1 Media Card Reader 2 USB cable 3 USB connector
9. Route the USB cable through the cable routing clip.
10. Replace the computer cover (see Replacing the Computer Cover).
11. Power up the system and enter system setup (see System Setup
). Set the USB for FlexBay value to ON.