17" LCD Color Monitor Dell E178FPC
27
6. Mechanical Instructions
Tools: 2 Power screwdrivers (φ=5mm,L=60mm); 1 small cross screwdriver; turnbuckle driver;
Setting: Power screwdriver torque A=11 kgF. Cm; torque B=6 kgF. Cm
Note: Firstly, put the monitor on a soft, flat and clean surface, wear gloves.
Fig Remark
Remove stand:
1. Rotate the stand to allow access
to the stand release button.
2. Press the Stand release button
and lift up the Stand and away from
the monitor.
Remove rear cover :
1. Remove the 4 screws by torque
A
2. Pry the monitor up then find out
the hooks’ position, use the tool
(like the picture or other card) to
insert into the gap of bezel and
rear cover.
To Next Page
Loading...
