Dell E178FPC - White Balance, Luminance Adjustment; Enter into the Factory Mode; Gain Adjustment; Max Brightness Measurement

17" LCD Color Monitor Dell E178FPC
55
10. White balance, Luminance adjustment
Approximately 2 Hours should be allowed for warm up before proceeding White-Balance
adjustment.
Before started adjust white balance, please setting the Chroma-7120 MEM. Channel 3 to 6500
0
K colors, MEM.
Channel 4 to 9300
0
K colors, MEM. Channel 9 to 5700
0
K (our 9300 parameter is x=283±30, y=297±30, Ymin
=160 cd/m
2
；6500 parameter is x =313±30, y=329±30, Ymin = 160 cd/m
2
, and 5700 parameter is x = 326 ±30, y =
349 ±30, Ymin = 160 cd/m
2
)
How to setting MEM.channel you can reference to Chroma-7120 user guide or simple use “ SC” key and “ NEXT”
key to modify x, y, Y value and use “ID” key to modify the TEXT description Following is the procedure to do
white-balance adjust
Enter into the factory mode:
Press MENU and “+” button during press Power button will activate the factory mode,
Gain adjustment:
Move cursor to “-Factory Setting-” and press MENU key to enter this sub-menu.
Move cursor to “Factory” and press MENU key.
Move cursor to “ Auto Level” and press MENU key to adjust Gain and Offset automatically;
a. Adjust sRGB (6500
0
K) color-temperature
1. Switch the Chroma-7120 to RGB-mode (with press “MODE” button)
2. Switch the MEM. channel to Channel 3 (with up or down arrow on Chroma-7120)
3.The LCD-indicator on Chroma-7120 will show x = 313 ±30, y = 329 ±30, Ymin = 160 cd/m
2
b. Adjust Color1 (9300
0
K) color-temperature
4. Switch the Chroma-7120 to RGB-mode (with press “MODE” button)
5. Switch the MEM.channel to Channel 4 (with up or down arrow on Chroma-7120)
6. The LCD-indicator on Chroma-7120 will show x = 283 ±30, y = 297 ±30，Ymin= 160cd/m
2
c. Adjust Color2 (5700
0
K) color-temperature
7. Switch the Chroma-7120 to RGB-mode (with press “MODE” button)
8. Switch the MEM.channel to Channel 9 (with up or down arrow on Chroma-7120)
9. The LCD-indicator on Chroma-7120 will show x = 326 ±30, y = 349 ±30，Ymin =160 cd/m
2
10. Move cursor to “Exit/Save” sub-menu and press MENU key to save adjust value and exit.
Turn the POWER-button off to on to quit from factory mode.
Max Brightness measurement: >230 cd/㎡
Test conditions:
a. Switch to the full white pattern, in user mode main menu:
1. Set <Color Settings> Red, Green, and Blue to the max.
2. Set <Brightness> Brightness, Contrast to the max.
b. The Minimum brightness is: < 40% of Max luminance (max luminance = max contrast + max brightness)
Test conditions:
Set <Brightness> Brightness, Contrast to the min.