Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #1
● Phillips screwdriver #2
● Torx T30 screwdriver
● 5 mm hex nut screwdriver
● 1/4-inch flat blade screwdriver
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity
Processor and heat-sink module Captive screws 4
Front PowerEdge RAID Controller (PERC)
module
Thumb screw - M3 2
Left control panel M3 8
Right control panel M3 8
Riser card 1 Captive screws 3
Riser card 3 Captive screws 1
2
10 Removing and installing components
To Next Page
Loading...
