Steps
1. Align the holes on the expansion card riser with the guides on the system board.
2. Push the release button on the riser and holding the edges lower the riser card 3 into its connector on the system board
connector.
3. Tighten the captive screw to secure the riser card 3 to the computer.
Next steps
1. Install the air shroud.
2. Install the system cover.
3. Follow the procedure in After working inside your computer.
Removing the riser card 4
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the system cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the riser card 4 and provide a visual representation of the removal procedure.
Removing and installing components
73
To Next Page
Loading...
