Steps
1. Insert the hard-drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the hard-drive with the screws holes on the drive carrier.
3. Replace the four screws to secure the hard-drive to the drive carrier.
NOTE:
If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
install the drive.
Next steps
1. Follow the procedure in After working inside your computer.
Air shroud
Removing the air shroud
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the system cover.
About this task
The following image indicates the location of the air shroud and provides a visual representation of the removal procedure.
26
Removing and installing components
To Next Page
Loading...
