Steps
1. Align the air shroud tabs with the slots in the computer.
NOTE: Ensure that the air shroud tabs are below the surface of the cooling cage fan assembly.
2. Press the air shroud down until the tabs clicks into place.
Next steps
1. Install the system cover.
2. Follow the procedure in After working inside your computer.
Processors and heat sinks
Removing the processor and heat-sink module
Prerequisites
1. Follow the procedure in Before working inside your computer.
WARNING: The heat-sink may become hot during normal operation. Allow sufficient time for the heat-sink to
cool before you touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat-sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the system cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the processor and heat-sink module and provide a visual representation of the
removal procedure.
Removing and installing components
29
To Next Page
Loading...
