Steps
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Press the memory module down with your thumbs until the securing clips firmly click into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Next steps
NOTE: AMD graphics cards cannot tie to memory over and including 1 TB.
1. Install the air shroud.
2. Install the system cover.
3. Follow the procedure in After working inside your computer.
Expansion card
Removing the riser card 1
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the system cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the riser card 1 and provide a visual representation of the removal procedure.
Removing and installing components
63
To Next Page
Loading...
