Steps
1. Align and place the front PERC module at an angle into its slot on the computer.
2. Tighten the two thumb screws to secure the front PERC to the computer chassis.
3. Connect the cable to its connector on the front PERC module.
Next steps
1. Install the backplane cover.
2. Install the system cover.
3. Follow the procedure in After working inside your computer.
Hard drive backplane
Removing the hard drive backplane
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the system cover.
3. Remove the backplane cover.
4. Remove the front PERC module.
About this task
The following images indicate the location of the hard drive backplane and provide a visual representation of the removal
procedure.
44
Removing and installing components
To Next Page
Loading...
