Steps
1. Remove the four screws from the slide rails on the drive carrier.
NOTE:
If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
remove the drive.
2. Lift the hard-drive out of the drive carrier.
Installing the hard-drive from the drive carrier
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the hard-drive from the drive carrier and provide a visual representation of the
installation procedure.
Removing and installing components
25
To Next Page
Loading...
