Steps
1. Align and slide the left control panel in the slot on the computer.
2. Route the left control panel cable through the side wall of the computer.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the left control panel cable to its connector on the system board.
5. Replace the eight screws to secure the left control panel and the cable cover to the system.
Next steps
1. Install the air shroud.
2. Install the cooling fan assembly.
3. Install the system cover.
4. Follow the procedure in After working inside your computer.
Removing and installing components
49
To Next Page
Loading...
