Dell EMC E39S Series - Installing the USB Module; VGA Module; Removing the VGA Module

Installing the USB module
Prerequisites
Follow the safety guidelines listed in Safety instructions on page 71.
NOTE: The procedure to install the USB 3.0 and USB 2.0 modules is similar.
Steps
1. Route the USB cable on the USB module, through the USB slot on the front panel.
2. Insert the USB module into the slot on the front panel.
3. Align the screw on the module with the screw hole on the system.
4. Using the Phillips #1 screwdriver, replace the screw to secure the module to the system.
5. Route the USB cable and connect it to the USB connector on the system board. For more information, see the System board jumpers
and connecters section.
Figure 101. Installing the USB module
Next steps
1. Install the air shroud.
2. Install the backplane cover.
3. Follow the procedure listed in After working inside your system on page 72.
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 71.
2. Follow the procedure listed in Before working inside your system on page 72.
3. Remove the front bezel
148
Installing and removing system components