EasyManuals Logo

Dell EMC E39S Series User Manual

Dell EMC E39S Series
173 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #152 background imageLoading...
Page #152 background image
Steps
1. Align the optical drive with the optical drive slot on the front of the system.
2. Slide in the optical drive until the release tab snaps into place.
Figure 105. Installing the optical drive
Next steps
1. Connect the power and data cables to the connector on the optical drive and the connector on the system board.
NOTE: Route the cable properly on the side of the system to prevent it from being pinched or crimped.
2. Follow the procedure listed in After working inside your system on page 72.
Power supply units
The power supply unit (PSU) is an internal hardware component which supplies power to the components in the system.
Your system supports one of the following:
Two 2400 W, 2000 W, 1600 W, 1100 W, 750 W, or 495 W AC PSUs
Two 1600 W, 1100 W, 750 W, 750 W Mixed Mode, or 495 W AC PSUs
Two 1100 W DC PSUs
Two 1100 W or 750 W Mixed Mode HVDC PSUs
NOTE: For more information, see the Technical specifications section.
CAUTION: If two PSUs are installed, both the PSUs must have the same type of label. For example, Extended Power
Performance (EPP) label. Mixing PSUs from previous generations of PowerEdge servers is not supported, even if the
PSUs have the same power rating. Mixing PSUs will result in mismatch condition or failure to turn the system on.
NOTE: Titanium PSU is nominally rated for 200 V AC to 240 V AC input only.
NOTE: When two identical PSUs are installed, power supply redundancy (1+1 – with redundancy or 2+0 – without
redundancy) is configured in system BIOS. In redundant mode, power is supplied to the system equally from both PSUs
when Hot Spare is disabled. When Hot Spare is enabled, one of the PSUs is put into the sleep mode when system
utilization is low in order to maximize efficiency.
NOTE: If two PSUs are used, they must be of the same maximum output power.
This section contains information about the hot spare features, wiring instructions for a DC power supply unit, removal and installation of
the power supply blank, and AC power supply unit.
152
Installing and removing system components

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell EMC E39S Series and is the answer not in the manual?

Dell EMC E39S Series Specifications

General IconGeneral
BrandDell
ModelEMC E39S Series
CategoryServer
LanguageEnglish

Related product manuals