Dell EMC E39S Series - Page 56

Viewing Network Settings
To view the Network Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Network Settings.
Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
Option
Description
UEFI PXE Settings
Options Description
PXE Device n (n =
1 to 4)
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the
device.
PXE Device n
Settings(n = 1 to
4)
Enables you to control the configuration of the PXE device.
UEFI HTTP
Settings
Options Description
HTTP Device (n =
1 to 4)
Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the
device.
HTTP Device n
Settings (n = 1 to
4)
Enables you to control the configuration of the HTTP device.
Table 41. HTTP Device n Settings screen details
Option Description
Interface Specifies the NIC interface used for this device.
Protocol Enables you to select protocol IPv4 or IPv6. This is
set to IPv4 by default.
VLAN Enables or Disable VLAN. This is set to Disabled by
default.
VLAN ID This is set to 1.
VLAN Priority This is set to 0.
URI (will obtain from DHCP server if not specified)
UEFI iSCSI
Settings
Enables you to control the configuration of the iSCSI device.
56 Pre-operating system management applications