Figure 109. Installing the VGA module
Next steps
1. Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the System
board jumpers and connecters section.
2. Install the air shroud.
3. Install the backplane cover.
4. Install the front bezel.
5. Follow the procedure listed in After working inside your system on page 35.
.
Optional internal USB memory key
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
For configurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system
board. In this scenario, the default internal USB port is available under the backplane cover. The position of the default internal
USB port may vary depending on the configuration of your system.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in Safety instructions on page 34.
2. Follow the procedure listed in Before working inside your system on page 35.
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the System board jumpers and connectors on page 137.
118
Installing and removing system components
To Next Page
Loading...
