Next steps
1. Install the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
2. Follow the procedure listed in After working inside your system on page 35.
Integrated storage controller card
Removing the integrated storage controller card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 34.
2. Follow the procedure listed in After working inside your system on page 35.
3. Remove the air shroud.
Steps
1. Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the
system board.
2. Lift the integrated storage controller cable to disconnect it from the connector on the system board.
Figure 75. Removing the integrated storage controller cable
3. Lift one end of the card and angle it to disengage the card from the card holder on the system board.
4. Lift the card out of the system.
Installing and removing system components
93
To Next Page
Loading...
