Figure 4. Front view of 10 x 2.5-inch drive system
Table 3. Features available on the front of the system
Item Ports, panels, and
slots
Icon Description
1 Left control panel N/A
Contains the system health and system ID, status LED, and the
iDRAC Quick Sync 2 (wireless) indicator.
NOTE: The iDRAC Quick Sync 2 indicator is available only
on certain configurations.
● Status LED: Enables you to identify any failed hardware
components. There are up to five status LEDs and an overall
system health LED (Chassis health and system ID) bar. For
more information, see the Status LED indicators section.
● Quick Sync 2 (wireless): Indicates a Quick Sync enabled
system. The Quick Sync feature is optional. This feature
allows management of the system by using mobile
devices. This feature aggregates hardware or firmware
inventory and various system level diagnostic and error
information that can be used in troubleshooting the
system. For more information, see the Integrated Dell
Remote Access Controller User’s Guide at www.dell.com/
poweredgemanuals.
2 Drive slots N/A
Enable you to install drives that are supported on your
system. For more information about drives, see the Technical
specifications section.
3 VGA port Enables you to connect a display device to the system. For more
information, see the www.dell.com/poweredgemanuals section.
4 Right control panel N/A Contains the power button, USB port, iDRAC Direct micro port,
and the iDRAC Direct status LED.
5 Information tag N/A
The Information Tag is a slide-out label panel that contains
system information such as Service Tag, NIC, MAC address,
and so on. If you have opted for the secure default access
to iDRAC, the Information tag also contains the iDRAC secure
default password.
For more information, see the Dell EMC PowerEdge R640 Technical Specifications on the product documentation page.
12
Dell EMC PowerEdge R640 overview
To Next Page
Loading...
