Figure 110. Removing the BOSS S2 controller card module
6. Remove the BOSS power cable and BOSS signal cable from the BOSS S2 controller card module.
Figure 111. Removing the BOSS power cable and BOSS signal cable from the BOSS S2 controller card module
7. Using the Phillips #1 screwdriver, remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS cover on the BOSS S2
controller card module. Slide the BOSS cover out from the BOSS S2 controller card module.
Installing and removing system components
125
To Next Page
Loading...
