Table 5. Right control panel (continued)
Item Indicator or button Icon Description
should not exceed 3 ft (0.91 meters). Quality of the
cable might affect performance.
NOTE: For more information about the ports, see the www.dell.com/poweredgemanuals section.
Rear view of the system
Figure 7. Rear view of the 10 x 2.5-inch drive system
Table 6. Rear view of the system
Item Ports, panels, or slots Icon Description
1 Power supply unit (PSU 1) For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals section.
2
PCIe expansion card riser
(slot 1)
N/A
The expansion card riser enables you to connect PCI
Express expansion cards. For more information about the
expansion cards that are supported on your system, see
www.dell.com/poweredgemanuals section.
3
PCIe expansion card riser
(slot 2)
N/A
The expansion card riser enables you to connect PCI
Express expansion cards. For more information about the
expansion cards that are supported on your system, see
www.dell.com/poweredgemanuals section.
4 USB 2.0 port (1) This port is USB 2.0-compliant.
5 Power supply unit (PSU
2)
For more information about the PSU configurations, see the
www.dell.com/poweredgemanuals section.
6
VGA port Enables you to connect a display device to the
system. For more information, see the www.dell.com/
poweredgemanuals section.
7 USB 3.0 port (1) This port is USB 3.0-compliant.
8 iDRAC dedicated port
Enables you to remotely access iDRAC. For more
information, see the iDRAC User’s Guide at www.dell.com/
poweredgemanuals.
9 System identification
button
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
System overview 13
To Next Page
Loading...
