Dell EMC PowerEdge R6525 - Installing the BOSS S2 Controller Card

Figure 112. Removing the BOSS cover
Next steps
1. Replace the BOSS S2 controller card module.
Installing the BOSS S2 controller card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Steps
1. Slide the BOSS cover on the BOSS S2 controller card module. Using the Phillips #1 screwdriver, secure the BOSS cover on
the BOSS S2 controller card module with the M3 x 0.5 x 4.5 mm screw.
126
Installing and removing system components