Air shroud
Removing the air shroud
Prerequisites
CAUTION: Never operate your system with the air shroud removed. The system may get overheated quickly,
resulting in shutdown of the system and loss of data.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Hold the edges of the air shroud, and lift the air shroud out of the system.
NOTE: The air shroud is required for the standard heat sink configuration. For the L-type heat sink configuration, air
shroud is not supported.
Figure 27. Removing the air shroud
2. For the air shroud on the rear drive module, hold the edges of the air shroud, and lift the air shroud out of the rear drive
module.
Installing and removing system components
39
To Next Page
Loading...
