CLI equivalent
Steps
1. To set up the administrator email, enter:
# config set admin-email dd_admin1@emc.com
The Admin Email is: dd_admin1@emc.com
2. To register the system to the gateway (Secure Remote Support), enter:
# support connectemc device register ipaddr esrs-gateway [host-list] [ha-peer ipaddr]
CAUTION: When configuring Secure Remove Services delivery on an HA pair:
● The ha-peer parameter is required when configuring Secure Remote Services on HA pairs to register
both nodes.
● The customer must provide Service Link credentials to run the support connectemc device register
command on an HA pair, because attempting to register the HA pair as a user will fail and cause the RSA
key token to become out of synch.
3. To enable the sending of autosupports, enter:
# support notification enable all
Enabled sending autosupport and alerts to EMC.
4. To set the notification method to ConnectEMC, enter:
# support notification method set connectemc
Support notification method set to "connectemc".
5. To show the notification setup, enter:
# support notification show all
Notification Status Destination
------------ ------- -----------------------
alerts enabled ftp://111.111.11.111:11
autosupport enabled ftp://111.111.11.111:11
------------ ------- -----------------------
6. To show the notification setup, enter:
# support connectemc config show
ConnectEMC configuration:
ESRS gateway IP/hostname: esrs-gateway.datadomain.com
Registered device IP(s) 10.25.246.70
7. To test the configuration after enablement, enter:
# support connectemc test
Sending a test event...
40
Configure System for Use
To Next Page
Loading...
